[debian] help configurare lirc seriale per freevo

[asghan]

ciao

vorrei attivare il telecomando su debian stable per utilizzarlo con freevo


su lenny funzionava bene con questa configurazione

cat /etc/serial.conf


/dev/ttyS0 uart none
   
/dev/ttyS1 uart none

 cat /etc/lirc/hardware.conf



# /etc/lirc/hardware.conf
#
# Arguments which will be used when launching lircd
LIRCD_ARGS=""

#Don't start lircmd even if there seems to be a good config file
#START_LIRCMD=false

#Don't start irexec, even if a good config file seems to exist.
#START_IREXEC=false

#Try to load appropriate kernel modules
LOAD_MODULES=true

# Run "lircd --driver=help" for a list of supported drivers.
DRIVER=""
# If DEVICE is set to /dev/lirc and udev is in use /dev/lirc0 will be                                                                          
# automatically used instead                                                                                                                   
DEVICE=""                                                                                                                            
MODULES="lirc_serial"                                                                                                                          
                                                                                                                                               
# Default configuration files for your hardware if any                                                                                         
LIRCD_CONF="/etc/lirc/lircd.conf"                                                                                                              
LIRCMD_CONF=""

dmesg
[   22.832618] lirc_dev: IR Remote Control driver registered, major 250 
[   22.853215] lirc_serial: module is from the staging directory, the quality is unknown, you have been warned.
[   23.752020] lirc_serial: auto-detected active low receiver
[   23.752202] lirc_serial lirc_serial.0: lirc_dev: driver lirc_serial registered at minor = 0

se in /etc/lirc/hardware.conf
inserisco DEVICE="/dev/lirc0"
non da errori pero non funziona

# /etc/init.d/lirc restart
[ ok ] Stopping remote control daemon(s): LIRC:.
[ ok ] Loading LIRC modules:.
[ ok ] Starting remote control daemon(s) : LIRC :.

grazie per gli eventuali consigli