VooDoo5 drivers bench

VooDoo5 drivers bench

di pubblicata il , alle 08:56 nel canale Uncategorized
 
The Tech Report ha pubblicato una pagina contenente informazioni e benchmarks in Quake3Arena dei nuovi drivers 1.03.00 per schede VooDoo5. Si può notare un discreto incremento perstazionale rispetto alla release precedente, specialmente ad alte risoluzioni, in cui le prestazioni sono limitate dalla potenza di calcolo della scheda video. Utilizzando un bench Direct3D si hanno invece incrementi molto leggeri, e un leggero decremento abilitando la nuova opzione "Geometry Assist". Trovate l'articolo a questo indirizzo

"Geometry Assist" wasn't a factor here, since it's only available in Direct3D. Good thing, too, since the new drivers actually came out slower in the low-res, 16-bit color test, where triangle throughput is probably the primary bottleneck. Across the board, otherwise, we see a consistent but minor performance boost. Nothing to write home about, though. (Hi, mom!) Maybe D3D would be a different story. I turned on Geometry Assist, which requires a reboot, and fired up 3DMark. With Geometry Assist enabled, 3DMark acts as if a hardware T&L engine is available. I chose "Hardware T&L" and ran the test. Then I switched back to "Pentium III" for another test. Finally, I turned off Geometry assist, rebooted once more, and ran 3DMark again using the "Pentium III" setting. Have a look at the results
0 Commenti
Gli autori dei commenti, e non la redazione, sono responsabili dei contenuti da loro inseriti - info

Devi effettuare il login per poter commentare
Se non sei ancora registrato, puoi farlo attraverso questo form.
Se sei già registrato e loggato nel sito, puoi inserire il tuo commento.
Si tenga presente quanto letto nel regolamento, nel rispetto del "quieto vivere".

La discussione è consultabile anche qui, sul forum.
 
^