cpu Prescott e abit ic7 max3

[impesta]

ciao a tutti e buon anno nuovo

dovrei prendere tale skeda madre...
sapete se rispetta le specifiche FMB 1.5 ? o comunque sara compatibile con il Prescott?
altre piastre ke potranno supportare tale cpu ?

il supporto x la cpu P4 Extreme Edition la darei x scontata!?

grazie

[seb87]

io ho già preso una max3 ma non ho trovato da nessuna parte qualche notizia che dica che tale scheda madre supporterà i prescott.

Cmq sono sicuro che tutte le ultime msi dal 865p, 875p e l' ultimo di via che non ricordo supporteranno i prescott .

P.s: almeno così c'è scritto nel sito

[emax81]

Originariamente inviato da impesta
ciao a tutti e buon anno nuovo

dovrei prendere tale skeda madre...
sapete se rispetta le specifiche FMB 1.5 ? o comunque sara compatibile con il Prescott?
altre piastre ke potranno supportare tale cpu ?

il supporto x la cpu P4 Extreme Edition la darei x scontata!?

grazie

ic7p13.exe Bios Issue Date:2003/10/30
BIOS ID:1.3
Fixed the problem that the hard disk on IDE-1 may not be detected by when "OnChip SATA" is set to RAID.
Fixed the problem that CAS latency can not be set manually when the CPU: DRAM is set to PSB800/5:4 or PSB800/3:2.
Remove some string in "PnP/PCI Configuration".
Fixed the problem that system will reboot instead of shutdown when the "Wake Up by Alarm" is enabled.
Fixed the problem that there will be some wording error when set "Time Alarm".
Fixed the problem that the system will shutdown if the fan speed is too low and the "Shutdown When CPU FAN Fail" is enabled.
Enhance USB card reader compatibility.
Add Pentium 4 Extreme Edition support.
Fixed HDD size detected as 136GB when 200/250/300 GB SATA drives are connected to SATA1 or SATA2 (ICH5 SATA channels)
Fixed the problem that certain CD/DVD-ROM could not be correctly detected when there is a HDD drive attached on the same IDE cable.
BIOS compile date: 10/30/2003

il P4 EE lo supporta, come dicono queste note dell'ultimo bios disponibile

[emax81]

ABIT had this to say about their current line of boards:


As a design partner of Intel, ABIT was able to design in support for future CPUs into our IS7 Series and IC7 Series of motherboards. Our motherboards follow the VRM 10.0 and FMB 1.5 Guidelines. With ABIT's 4-phase power onboard and a strengthened PWM design, ABIT users of the IS7 Series and IC7 Series are able to use current Northwood core Pentium 4s as well as upcoming CPUs.

Interestingly enough, they do not mention their new AI7/i865PE board above, but FMB 1.5 is even spelled out in the specifications as “supported” by the chipset.


Supports Advanced Configuration and Power Management Interface (ACPI) & FMB 1.5

Link

[HyperOverclock]

Anche nel manuale della max3 è dato il supporto al prescott.

[impesta]

ok la prendo!
grazie