|
|||||||
|
|
|
 |
|
|
Strumenti |
06-07-2006, 11:26
|
#1 |
|
Member
Iscritto dal: Oct 2005
Messaggi: 50
|
Xerox Phaser 8400
Qualcuno sa dirmi cosa è il codice d'errore 07.010.43? Sul sito dedlla xerox dicono solo di chiamare l'assistenza....
 ghghg
|
|
|
|
06-07-2006, 11:40
|
#2 |
|
Senior Member
Iscritto dal: Sep 2005
Città: milano
Messaggi: 2091
|
Phaser 8400 error 07.010.43 From the service manual:
7,010.4x: PM_FAULT_HEADTILT_HOME_ERROR The printhead is stuck in the tilt position by the tilt arms. The process motor gearbox being out of sync can also cause this error. 1. Reboot the printer. 2. Verify the lock arms rotate correctly. 3. Check for spilled ink around the printhead. 4. Check the process motor gears for damage. Ensure the process gears are correctly aligned and homed. 5. Verify the process gear box, process shaft, and drive module shaft are at home position. 6. Verify the headtilt gear will engage, see the home positioning procedure on page. You can manually engage the headtilt gear. 7. Run the Tilt Axis Drive test. 8. Run the Process Motor test. 9. Run the Head Maintenance Clutch test, if the test fails replace the clutch. 10. Run Wiper Drive test. If this fails inspect the wiper drive system. E' bastato google 
__________________
Ho concluso con: Corvax, Phopho, dr.gazza, geminiII, Bladexx, Thebaro, JAN THE LAST, Trapana, w-shark, ilBenny(x2), ChriD, Estero, keemax, mspr, GIVDYX |
|
|
|
|
06-07-2006, 13:06
|
#3 |
|
Member
Iscritto dal: Oct 2005
Messaggi: 50
|
 beh non c'ho provato effettivamente
|
|
|
|
|
|
| Strumenti | |
|
|
Tutti gli orari sono GMT +1. Ora sono le: 11:56.
