Retrocedere dal firmware Ausraliano..????!!!!!!!!!

[Cokiere]

Ciao raga
ho da poco aggiornato il mio D-Link dsl504T con firmware AU; ma non mi antusiasma: non riesco a mantenere il setaggio, quando spengo e riaccendo devo settare nuovamente il tutto; il router non mi sembra molto sveglio....
Posso retrocedere??

Ho provato ad entrare tramite telnet, ma qundo c'è da inserire la PASS non mi funziona la tastiera...è possibule??


Ecco il setaggio per il firmware AU:

DSL-504T 2.00B01T01 Firmware with ADSL2/2+ Support

Please read this document prior to proceeding with the upgrade.

- D-Link Australia does not guarantee that this firmware
is fully compatible with all Internet Providers' DSLAMs.
- Please confirm with your Internet Provider the availability
of ADSL2/2+ services in your area.
- Upgrading the modem/router to the ADSL2/2+ firmware is not
reversible without returning the product to D-Link Australia
RMA Dept. This will incur a service charge.


DSL-504T FIRMWARE 2.00B01T01 UPGRADE STEPS:

- Download the firmware file and extract it into any folder on
your computer.
- FACTORY RESET the unit before upgrading.
- Connect the DSL-504T directly to your computer via network cable
(do not use wireless connection).
- Disable Firewall/Antivirus software on your computer.
- !!!IMPORTANT!!! You must assign a static IP address to your PC
before upgrading the firwmare, otherwise it will corrupt your unit.
E.g: IP address: 10.1.1.5, Subnet Mask 255.0.0.0,
Default Gateway 10.1.1.1.
- Run the firmware upgrade utility.
When prompted, enter the unit's IP address (10.1.1.1)
and username/password (admin/admin).
- Do not turn the unit off while loading firmware.
- Note that you cannot downgrade to previous firmware's once
you have upgraded to v2.00b01T01.


Note for DSL-504T users in New Zealand: you will need to change
VPI/VCI settings in the router to 0/100.