Periferica ATA e gestione acustica!

[somfy]

Pare che ho 2 problemini da risolvere.
Facendo dei test con SISOFTWARE SANDRA, su inf. ATA/ATAPI mi da 2 msg. di allerta:[list=1][*]Warning W3103 - Acoustic Management enabled. While this reduces the noise the drive generates, the performance is almost always impaired. Most of the time fans generate more noise than the drive itself. If the drive does generate a lot of noise, it may be faulty. You could also consider swapping the drive for another model that generates less noise.[*]Warning W3104 - Current transfer mode not optimal, i.e. not highest supported. This affects drive performance. If the controller is also capable of the highest supported transfer mode, there is no reason not to use it. [/list=1]

Per il primo non so proprio che pesci pigliare, (non ho idea di come si possa disabilitare tale funzione acustica)
Per il secondo idem, per come riesco ad interpretare il msg. e dai controlli effettuati non emerge nulla che mi porti risolvere il problema.
SISOFT SANDRA come soluzione mi da quanto:
Soluzione: First check controller supported transfer modes. Then check the mode the driver for the controller/BIOS is set to use and modify; some default to a lower mode for compatibility. You may need to install newer drivers if the current drivers do not natively support the controller (especially for RAID). You may need to update the controller BIOS or drive firmware if the mode does not stick. If data corruption occurs consider verify cable and consider switching (if any) drives on the same channel on other channels.

If the built-in controller does not support the mode, consider using the on-board/RAID controller or even disable the built-in controller and install a new controller.

Chi mi RISOLVE????

[somfy]

up!

[somfy]

C'è nessuno che mi da una mano???