riporto parte di 1 readme che mi chiede di fare cose strane

[^[H3ad-Tr1p]^]

salve a tutti
siccome nn sono in grado di installare queste librerie,riporto parte di 1 readme che mi chiede (mi pare )di configurare la shell mi pare di aver capito ma nn ne sono sicuro xche' l eng nn e' il mio forte

mi potete spiegare ch operazioni mi chiede di fare?
io ho prvato col primo comando e mi vengono fuori 1 mucchio di opzioni da configurare....nn vorrei fare dei casini


This file was pre-historic - so I have pruned it to the essentials,
and the bits that still looked correct.

With modern perl and CPAN.pm you should be able to type:

perl -MCPAN -e shell
make NI-S/Tk800.0_01.tar.gz

Or do it by hand as follows:

get the Tk800.0_01.tar.gz file - use binary mode if FTP'ing.

Unpack it e.g.

zcat Tk800.0_01.tar.gz | tar xf -

cd to the directory distribution unpacks to.

perl Makefile.PL
make
make test

If Makefile.PL reports that it cannot find X, or chooses a version
you don't like you can specify a version on the command line:

perl Makefile.PL X11=/usr/local/X11R5

If X's include and lib are not under a common parent they can be specified
separately:

perl Makefile.PL X11INC=/usr/local/share/X11R5/include X11LIB=/usr/local/arch/X11R5/lib

'make test' is a little tedious as it re-checks all the dependancies.

perl -Mblib demos/widget

Does more-or-less the same thing.
You can also run the less polished 'demos' in the top level directory
the same way e.g.:

perl -Mblib basic_demo

You should now install using one of
the make targets:

make install # normally site unless overridden as above

make INSTALLDIRS=perl # Force perl

make INSTALLDIRS=site # Force site

Above call these targets (which may not survive MakeMaker changes):

make install_site # Force site
make install_perl # Force perl

Once installed the demos in the demos sub-directory should run
(if #! line is right):

./demos/widget