nf7 + SATA

[neme]

SiI3x12A: Serial ATA (SATA) Windows RAID Driver - Released
NEW ? Version 10032 of the SiI3x12 Windows RAID driver is now logo-certified for Windows 2003 Server.
The latest Windows RAID driver for the SiI3x12A SATA Controller chip (3x12A_x86_win_rdrv-xxxxx.zip) can be downloaded from the links on the right.__ These drivers support Windows 98SE/ME/NT/2000/XP._ Windows 95 is not supported.
Please NOTE that these are the latest GENERAL drivers that are available from Silicon Image. Some motherboard or add-in card makers may post versions with later revision numbers than the one shown here, but those are written specifically for their designs and are not intended for general use.
The latest version of Silicon Image SATARAID RAID Manager software is also attached on the right.
_
Comments/Special Instructions:
Preparing a 'Silicon Image SiI 3x12 Raid Driver Installation Disk'
Follow these instructions if you are creating a diskette containing the Silicon Image SiI 3x12 Raid driver.
1. Format a blank floppy diskette.
2. Use WinZip or a similar utility to unzip the Driver Zip file (3x12A_x86_win_rdrv-xxxxx.zip).Make sure you use the rdrv file and NOT the SATARAID file. The SATARAID file is the Windows RAID Manager GUI. It is not the RAID driver and will be too large to fit on a floppy. If it does not fit on a floppy, you are using the wrong file.
3. Copy all the files contained in the zipped file to the newly formatted diskette.
4. Label this floppy diskette 'Silicon Image SiI 3x12 RAID Driver Installation Disk'.

Perchè la mb non riconosce SATA nonostante l'aver installato i driver? Jumpers? Devo riformattare e installare da floppy con F6? Quale è la procedura completa?