Hard Disk, Qualcosa non va?

[mrchat9]

Ragazzi è da qualche tempo che all'avvio del pc dall'altoparlante di sistema dopo il classico bip del bios, c'è un susseguirsi di bip che non risco a capire cosa sia. Visto che a volte mi capita che il pc si spegne di botto ho pensato bene di controllare le temperature con SpeeFan, ho dato un'occhiata anche al controllo on-line dell'hard disk ed ecco cosa mi dice:

Your hard disk is a Maxtor 6Y080L0 with firmware YAR41BW0.
The average temperature for this hard disk is 33C (MIN=18C MAX=46C) and yours is 31C.
Your hard disk's S.M.A.R.T. attributes are now being analyzed and a full report about the reliability, health and status of your hard disk is generated:
Your hard disk is not below any attribute threshold. This is good.
Your hard disk was never below any attribute threshold. This is good.
Your hard disk is now being compared to real data used to define normal values for your specific hard disk model. This way, the analysis can automatically use proper operating ranges. The images give you an idea of how each attribute is within such range. Current and raw values are shown for easier reference for experienced users. There are 1742 hard disk models in the current archive.

Attribute Current Raw Overall
Spin Up Time 225 10484 Good
Start/Stop Count 253 89 Very good
Reallocated Sector Count 253 0 Very good
Read Channel Margin 253 0 Very good
Seek Error Rate 253 0 Very good
Seek Time Performance 248 63794 Normal
Power On Hours Count 252 35885 Very good
Spin Retry Count 253 0 Very good
Calibration Retry Count 253 0 Very good
Power Cycle Count 246 3143 Watch
Warning: Power Cycle Count is below the average limits (248-253). Power Off Retract Count 253 0 Very good
Load Cycle Count 253 0 Very good
Hardware ECC Recovered 253 4691 Very good
Reallocated Event Count 253 0 Very good
Current Pending Sector 253 0 Very good
Offline Uncorrectable Sector Count 253 0 Very good
Ultra DMA CRC Error Rate 199 0 Very good
Write Error Rate 253 0 Very good
Soft Read Error Rate 253 14 Very good
TA Increase Count 253 0 Very good
Run Out Cancel 253 16 Very good
Shock Count Write Opern 253 0 Very good
Shock Rate Write Opern 253 0 Very good
Spin High Current 253 0 Very good
Spin Buzz 253 0 Very good
Offline Seek Performance 253 0 Very good
Unknown attribute 99 253 0 Very good
Unknown attribute 100 253 0 Very good
Unknown attribute 101 253 0 Very good


NOTE: not all warnings are reflected on fitness and performance overall values as relevancy is based upon the settings from the hard disk manufacturer who is the best entity deputed to define such relationships.

NOTE : your hard disk Power Cycle Count attribute current value (246) is below the normal range (248 - 253) reported for your specific hard disk model. Basically your hard disk was power cycled more times than the maximum number the average hard disk was. Power cycles put some stress on the hard disk mechanic. Sometimes power cycles can be caused by a loose hard disk power connector. Make sure it is properly fastened.


The overall fitness for this drive is 90%.
The overall performance for this drive is 90%.
The link to get back and see a new report about this hard disk in the future is this. Consider that new hard disks and new checks are added over time.

Che vuol dire la frase in rosso? Potrebbe essere lei la causa di questi malfunzionamenti?