Alimentatore MicroAtx per HTPC

[kyuss]

Dopo un pò di ricerche ho trovato un'alimentatore MicroATX, l'unico che posso montare dentro un case Dign, con una potenza di 480W.
Non che debba alimentare chissà quale potenza, ma rispetto la media che ho trovato che si aggira sui 300W.... e visto che il futuro non sembra puntare molto alla riduzione dei consumi.

Queste la caratteristiche

* High efficiency (Focus on New System & Gaming System)
* Low Ripple & Noise, Dual Fan (With Temperature Fan Speed Control)
* With 20/24pin ATX Connector Support Intel 915 &925 Chipset.
* SATA HD Connector + PCI Express
* Output over voltage protection

Short circuit protection on all outputs

Reset table power shut down
* Approved by UL, CB & CE
* Complies with FCC part 15 subpart J Class B at 115VAC operation &
CISPR 22 Class B at 230 VAC operation
* 100% burn-in under high ambient temperature (50¢J)
* Vacuum-impregnated transformer
* MTBF: 100K hours at 25¢J
* FULL RANGE 100~240VAC (400W)
* Dimension: 5" (W) X 2.5" (H) X 4.75" (D)
* 3 Peripherals, 1 Floppy, 1 20/24pin, 1 ATX12V, 1 SATA 1PCI EXPRESS + 4pins HP Video connector included (for some HP models)!

Note: The model also work with certain HP & eMACHINE models. It comes with extra feature (HP Video Connector). If the model you are replacing doesn't have or NOT using this connector, you can just ignore it.



AC INPUT: 115/230 Vac~ 10/5A 60/50Hz
(+3.3v and +5v MAX OUTPUT 230W, Peak Surge Max Output 498W)

+3.3V - 14A

+5V - 24A

-5V - 0.5A

12V - 24A

-12V - 0.8A

+5V-SB -2.5A








com'è secondo voi?