Sirftech e Asus MyPal A636N

[castu]

Devo aver combinato un casino con Sirftech perchè prima il palmare mi funzionava in ricezione NMEA sia con WInCEMonitor, sia con VisualGPSCE, sia con TOMTOM.
Ho fatto un clean boot ma mi sembra che i parametri del GPS su Sirftech siano rimasti invariati.
C'è qualche buonanima che mi può incollare i parametri con i quali l'ASUS A636N si presenta col Sirftech?

[castu]

a chi interessa qui è segnalato un ottimo post per reimpostare le impostazioni di fabbrica del chip GPS integrato dopo modifiche con Sirftech, funziona con la maggior parte dei gps integrati nei palmari.
Preso dal forum GPSPAssion:
"Open the Comm dialog by tapping the menu Comm.

If the protocol is NMEA:
- Close the Comm dialog by tapping OK.
- Open the NMEA dialog by tapping the NMEA menu.
- Select a baudrate you know is supported by BC-337 and tap the button to switch to SiRF protocol.
- Close the NMEA dialog by tapping OK.

If the protocol is SiRF:
- Close the Comm dialog by tapping OK.
- Open the SiRF property sheet by tapping SiRF menu.

- Assuming you only want to change to NMEA protocol at 4800 baud, go to the 'Switch to NMEA Protocol' sheet.
- Select Baudrate 4800 and tap the Set button.
- When the UTC stops updating, the command has taken effect. Tap Set again if nothing happens.
- Close the SiRF property sheet by tapping OK.
- Open the Comm dialog by tapping the menu Comm.
- Close the comm port by tapping the Close button.
- Open the comm port at the new baudrate by tapping the Open button.

- Assuming you want to set everything to default settings go to the 'Initialize Data Source' sheet.
- Select Factory Reset.
- Tap the Set button a couple of times.
- Close the SiRF property sheet by tapping OK.
- Open the Comm dialog by tapping the menu Comm.
- Close the comm port by tapping the Close button.
- Open the comm port at the default baudrate 4800.

I know nothing about the Globalsat BC-337 so someone else might know better.

Best Regards
Dennis Gröning
"