Overclok con con ram Twinmos

[cypher85]

Ho 2 kit da 2x512 montate sul mio pc di queste ram :
dalle specifiche qua sotto mi sapete dire se con queste ram posso aver un buono overclok , oppure s'è meglio usare solo un kit e mettere in t1 ?

PC3200 / DDR400 184 Pin Unbuffered DIMM
Dual Channel Kit Capacity Chip Configuration ECC Chip Type
512MB 256MBx2 32Mx8(x8) non-ECC DDR SDRAM
1GB 512MBx2 32Mx8(x16) non-ECC DDR SDRAM
2GB 1GBx2 64Mx8(x16) non-ECC DDR SDRAM


* Backward compatible with dual channel DDR400/333/266 MHz

* Ensue system stability with the lowest MTBF feature

* Single module perform Data Transfer Rate up to 3200MB/s

* A whopping 6.4GB/s of memory bandwidth

* Effectiveness overcoming PC2700 & Rambus800/1066/1200

* Easily expand extra modules anytime

* The matched pair of dual channel kit modules are all been verified in the dual channel environment and proved through testing to achieve high performance and stability

* Double Data Rate architecture
* MRS cycle with address key programs
*CAS latency: CL2 / 2.5
*Burst length: 2, 4, 8
*Burst type: Sequential & Interleave
* 2 variations of refresh
*Auto refresh
*Self refresh
* Serial Presence Detect support
* 2 Banks to be operated simultaneously or independently
* Package: TSOP/CSP
* 184 edge connector pads
* Data Rate: 400MHz
* Clock frequency: 200MHz
* Bus width: 64-bit x 2
* Data Bandwidth: 6.4GB/s
* SSTL-2 interface: 2.6 Voltage +/- 0.1V