Golden Orb e instllazione

Golden Orb e instllazione

di pubblicata il , alle 08:56 nel canale Uncategorized
 
PCMECH ha pubblicato un'utile guida pratica, corredata da numerose immagini, alla corretta installazione del cooler ThermalTake Golden Orb in versione Slot1/SlotA. Trovate l'articolo a questo indirizzo

OK after clipping my "Orb" to the processor, here is the final product. It is simple to install, but please, be careful not to "bend" your processor too much. Be gentle. As you can see in the center, under the fan sink, there are two shiny metal clips. Underneath, there are two metal "studs" (refer to previous picture) that fit into the processor. In this photo, take note at the bottom of the picture, that is the bottom of my processor and that is the ONLY way the orb will fit on. So when you are trying to fit your "Orb" onto your processor, make sure you have it turned the correct way. After that "insert" your clips, snap them into place, and you are ready to put your processor back in your PC
0 Commenti
Gli autori dei commenti, e non la redazione, sono responsabili dei contenuti da loro inseriti - info

Devi effettuare il login per poter commentare
Se non sei ancora registrato, puoi farlo attraverso questo form.
Se sei già registrato e loggato nel sito, puoi inserire il tuo commento.
Si tenga presente quanto letto nel regolamento, nel rispetto del "quieto vivere".

La discussione è consultabile anche qui, sul forum.
 
^