|
questo č quello che ho fatto io
"Please read below instruction carefully to flash the firmware. It's a bit complicated.
[Instruction]
1. Unzip attached zip file and copy extracted files to a DOS bootable disk.
2. Connect ND-6500A to secondary master. Do not connect anything on secondary slave.
3. Boot the system with the DOS bootable disk.
4. From DOS prompt, type "6500BOOT.bat" and press enter.
5. After the flash is completed, shut down the system.
6. Then boot the system with the DOS bootable disk again and confirm the drive is now seen at secondary slave. If not, please check the BIOS setup.
7. From DOS prompt, type "6500MAIN.bat".
8. After the flash is completed, shut down the system."
|