View Single Post
Old 11-02-2005, 13:23   #5
Artiko
Senior Member
 
L'Avatar di Artiko
 
Iscritto dal: Nov 1999
Città: BG MI
Messaggi: 2513
vedo che i moderatori sono tutti in ascolto!

Adesso faccio polemica!!!

Cavolo sono mesi e mesi che c'è in rilievo un topic del c@@o di uno che offriva un posto di lavoro che poi non ha nemmeno dato (mi sembra tanto un piccolo BERLUSCONI) e non mettete in rilievo questo topic che è molto utile visto che stanno ingolfando tutto il forum con le stesse domande!

Un po' di dedizione al dovere!


DOPO QUESTO SFOGO, e spero che venga ascoltato veniamo a noi.


Ecco perchè il firmware dei russi sul 302t non funziona:

Qui il log completo:

Executing the RAM image at 0x941bc980.
Launching kernel LZMA decompressor.
Kernel decompressor was successful ... launching kernel.

LINUX started...
Config serial console: ttyS0,38400
CPU revision is: 00018448
Primary instruction cache 16kb, linesize 16 bytes (4 ways)
Primary data cache 16kb, linesize 16 bytes (4 ways)
Number of TLB entries 16.
Linux version 2.4.17_mvl21-malta-mips_fp_le ([email protected]) (gcc
version 2
.95.3 20010315 (release/MontaVista)) #1 ðÎÄ æÅ× 7 00:46:16 MSK 2005
Determined physical RAM map:
memory: 14000000 @ 00000000 (reserved)
memory: 00020000 @ 14000000 (ROM data)
memory: 007e0000 @ 14020000 (usable)
On node 0 totalpages: 2048
zone(0): 2048 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line:
the pacing pre-scalar has been set as 600.
calculating r4koff... 000b71b0(750000)
CPU frequency 150.00 MHz
Calibrating delay loop... 149.91 BogoMIPS
Freeing Adam2 reserved memory [0x14001000,0x0001f0
Memory: 6368k/8192k available (1475k kernel code, 1824k reserved, 115k
data, 52k
init)
Dentry-cache hash table entries: 1024 (order: 1, 8192 bytes)
Inode-cache hash table entries: 512 (order: 0, 4096 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 2048 (order: 1, 8192 bytes)
Checking for 'wait' instruction... unavailable.
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Disabling the Out Of Memory Killer
devfs: v1.7 (20011216) Richard Gooch ([email protected])
devfs: boot_options: 0x1
Squashfs 2.1-r2 (released 2004/12/15) (C) 2002-2004 Phillip Lougher
pty: 32 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with no serial options enabled
ttyS00 at 0xa8610e00 (irq = 15) is a 16550A
ttyS01 at 0xa8610f00 (irq = 16) is a 16550A
block: 64 slots per queue, batch=16
Using the MAC with internal PHY
PPP generic driver version 2.4.1
PPP MPPE Compression module registered
avalanche flash device: 0x400000 at 0x10000000.
Physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
request_module[cfi_cmdset_0003]: Root fs not mounted
Support for command set 0003 not present
gen_probe: No supported Vendor Command Set found

(grazie allo sbattimento di andrea.usenet)

ora sembra che il problema risieda nel fatto che nel 302t venga usata una flash memory della INTEL, non compatibile con quella usata nei 300t ovvero una AMD!

E' incredibile...


Segue risposta del team mcmcc:

Now to me it is clear, why for you the device is not started, tell please,
what chip flash costs to memory in your device? In our devices flash memory
costs Amd/Fujitsu compatible, and in 302T, I so understand, another...

ora stanno lavorando per rendere compatibile la prossima versione con l'hardware 302t.

inoltre installeranno anche il demone per la porta USB, in modalità 2.0!
Artiko è offline