View Single Post
Old 03-06-2003, 00:59   #3477
spocky
Senior Member
 
L'Avatar di spocky
 
Iscritto dal: Oct 2001
Cittā: Latina
Messaggi: 743
Re: TERZO HARD DISK (IDE) SUL SATA ... nn va

Quote:
Originally posted by "Mister Metal"



Mi riferivo appunto ai connettori serial ata..

Pare che non sei il solo ad avere il serillel scassato (tipo marvel)
c'e' un altro nel forum che ha problemi
forse ci sono in giro mobo nf7-f un po' malfunzionanti
sei in garanzia vedi un po' tu.

Ti e' piaciuto il mio yacht ???
Karlini da allora fa lo gnorri, si vede sempre piu' di rado



Vedo che su abit-usa che c'e' un tuo fratello gemello
------------------------------------------------------------------------
Problem with SATA and Maxtor disks

I have two Maxtor DiamondMax 9 Plus disks that I want to stripe using raid-0 but I can't get it to work! The BIOS can't detect any disks at all and WinXP stops dead if any of the disks are connected.

I bought a NF7-S mobo which included only one seriell-adapter so I bought an extra adapter, SI-0718SA, which unfortuntly contains the marvell-chip. This might explain why one of the disks isn't detected, but what about the adapter that is included with the mobo - is it also using the marvell-chip?

I've tried the nforce 2.03 drivers and 2.42 but WinXP (SP1) refuses to boot.

Anybody got an idea of what is going on?
-------------------------------------------------------------------------------------

Ma hai visto che chip ha il tuo serillel ?
Un tale usa Highpoint RocketRaid 100 convertors...
Good night

Carino lo yacht, ma mi sa che ora te ne dovrai comprare uno nuovo

In effetti quel mio fratello amiricano sembra che abbia prorpio il mio stesso problema.

Ma come faccio a vedere che chip monta l'adattore ?
Lo devo aprire !!
__________________
Intel CoreI7 - 3x2gb ddr3 - Asus P6T - Asus ENGTX260 768 mb - Raptor 80gb + WD 320
spocky č offline   Rispondi citando il messaggio o parte di esso