[tonello]

N so se può interessarvi, ma lo metto lo stesso: una guida ai bip della nostra cara mobo

**Abit NF7-S Beep Codes
Basic Beep Codes for ABIT AWARD BIOS Motherboards

No beep at all - this means your motherboard is dead, either due to a defective or underpowered power supply, poorly seated CPU or RAM, or a dead-on-arrival board


One beep - board is working fine


One long beep then machine shuts down - faulty, improperly installed or missing CPU


1 short(Beep) System booting is normally


2 short(Beep) CMOS setting error


1 long - 1 short(Beep) DRAM ERROR


1 long - 2 short(Beep) Display card or monitor connected error


1 long - 3 short(Beep) Keyboard Error


1 long - 9 short(Beep) ROM Error


Long(Beep) continuous DRAM isn't inserted correctly


Short(Beep) continuous POWER supply has a problem


A two-tone siren, generally caused by overheating or out of specification voltages


Four beeps then machine shuts down. This is because this version of the BIOS will shut down your machine if no fan tachometer signal is detected on the fan header. Make sure you attach a fan to the FAN1 or FAN4 header or clear CMOS to reset to default (no checking).


Thanks to Paul Howland & Overclockers for providing the information.