|
Re: netneo(macerata)
Nell'help ho trovato questo:
BUT, below You will find method to reset C42/C62 cartridges:
1) Move cartridge to exchange position using functions build in this utility.
2) Remove cartridge
3) You will see small chip with few contacts. Configuration of contacts is shown below :
1 2 3
4 5 6 7
4) Use very thin adhesive tape to cover only first contact.
5) Insert cartridge back. Also note, what You can exchange CSIC chips in color and black cartridges.
6) Move head to parking position and turn printer off.
7) You can also try to use reset printer counters function here.
8) Turn printer on back - it must say what black cartridge (is You covered chip contact on black one) is installed wrongly (red light on), but color or black cartridge level can became full at this time. Red light must became off after some time, but it can happen what it remain on.
9) If cartridge didn't became full (old values or 1/4) try turn off printer and repeat sequence from step 7).
10) Use normal cartridge exchange build in Epson drivers (or by printer buttons) to remove adhesive tape.
This procedure can be ineffective, especially for non-original cartridges.
...però non sono riuscito ad eseguirlo!
Ssc non mi tiene più i contatori, il chipresetter non mi funziona e nemmeno con questo metodo sono riuscito a ri-sbloccare 'ste cartucce. Una volta che segna "inchiostro esaurito" è un casino tornare indietro.
Ma è possibile che la stampa di una pagina abbia portato il contatore del nero dal 8 allo 0%? 12 pagine e finisce la cartuccia!
|