ciao
vorrei attivare il telecomando su debian stable per utilizzarlo con freevo
su lenny funzionava bene con questa configurazione
Codice:
cat /etc/serial.conf
/dev/ttyS0 uart none
/dev/ttyS1 uart none
Codice:
cat /etc/lirc/hardware.conf
# /etc/lirc/hardware.conf
#
# Arguments which will be used when launching lircd
LIRCD_ARGS=""
#Don't start lircmd even if there seems to be a good config file
#START_LIRCMD=false
#Don't start irexec, even if a good config file seems to exist.
#START_IREXEC=false
#Try to load appropriate kernel modules
LOAD_MODULES=true
# Run "lircd --driver=help" for a list of supported drivers.
DRIVER=""
# If DEVICE is set to /dev/lirc and udev is in use /dev/lirc0 will be
# automatically used instead
DEVICE=""
MODULES="lirc_serial"
# Default configuration files for your hardware if any
LIRCD_CONF="/etc/lirc/lircd.conf"
LIRCMD_CONF=""
Codice:
dmesg
[ 22.832618] lirc_dev: IR Remote Control driver registered, major 250
[ 22.853215] lirc_serial: module is from the staging directory, the quality is unknown, you have been warned.
[ 23.752020] lirc_serial: auto-detected active low receiver
[ 23.752202] lirc_serial lirc_serial.0: lirc_dev: driver lirc_serial registered at minor = 0
se in /etc/lirc/hardware.conf
inserisco DEVICE="/dev/lirc0"
non da errori pero non funziona
Codice:
# /etc/init.d/lirc restart
[ ok ] Stopping remote control daemon(s): LIRC:.
[ ok ] Loading LIRC modules:.
[ ok ] Starting remote control daemon(s) : LIRC :.
grazie per gli eventuali consigli