Sono riuscito ad entrare nell ARMBOOT !
Smontando il disco, si accede a un pulsante di reset sul PCB (S2).
Tenendolo premuto allaccensione, si ottiene questo sulla console:
# STR9100>
Digitando ? compare la lista comandi:
go - start application at address 'addr'
run - run commands in an environment variable
bootm - boot application image from memory
bootp - boot image via network using BootP/TFTP protocol
tftpboot- boot image via network using TFTP protocol
and env variables ipaddr and serverip
firstboot- first boot the device for mass production
rarpboot- boot image via network using RARP/TFTP protocol
bootd - boot default, i.e., run 'bootcmd'
loads - load S-Record file over serial line
loadb - load binary file over serial line (kermit mode)
autoscr - run script from memory
md - memory display
mm - memory modify (auto-incrementing)
nm - memory modify (constant address)
mw - memory write (fill)
cp - memory copy
cmp - memory compare
crc32 - checksum calculation
base - print or set address offset
printenv- print environment variables
setenv - set environment variables
saveenv - save environment variables to persistent storage
protect - enable or disable FLASH write protection
erase - erase FLASH memory
flinfo - print FLASH memory information
bdinfo - print Board Info structure
iminfo - print header information for application image
loop - infinite loop on address range
mtest - simple RAM test
reset - Perform RESET of the CPU
echo - echo args to console
sleep - delay execution for some time
version - print monitor version
help - print online help
? - alias for 'help'
MOOOLTA ATTENZIONE AL COMANDO:
loadb - load binary file over serial line (kermit mode)
Bye!