Quote:
Originariamente inviato da Harry_Callahan
è giusto
allora, come suggerito da pegasolabs, diamo un'occhiata ai valori di linea
dovresti avere questi valori in maintence-->show statistics(per la velocità)
e in diagnostic, downstream noise margin(i valori SNR)
se cosi non fosse cerca le seguenti voci, tanto i menù non sono infiniti:
SNR Downstream
Attenuation Downstream
Bitrate, Data Rate, o qualcosa di simile
|
System up Time: 4:01:59
CPU Load: 3.03%
WAN Port Statistics:
Link Status: Up
Upstream Speed: 352 kbps
Downstream Speed: 2464 kbps
Node-Link Status TxPkts RxPkts Errors Tx B/s Rx B/s Up Time
1-PPPoE Up 211881 205484 0 0 0 0:13:36
LAN Port Statistics:
Interface: Status TxPkts RxPkts Collisions
Ethernet Up 202531 224806 0
relative capacity occupation: 31%
noise margin downstream: 33.0 db
output power upstream: 12.0 dbm
attenuation downstream: 14.0 db
carrier load: number of bits per symbol(tone)
tone 0- 31: 00 00 00 03 34 56 66 76 67 66 67 66 65 54 22 00
tone 32- 63: 00 00 00 00 00 00 22 22 22 33 33 34 44 44 44 44
tone 64- 95: 04 44 44 44 44 44 44 44 44 44 44 44 54 55 54 52
tone 96-127: 45 54 45 55 55 45 45 44 44 44 45 45 44 45 44 54
tone 128-159: 44 55 55 55 55 44 44 44 44 44 44 44 44 44 44 44
tone 160-191: 44 44 44 44 44 44 44 44 44 44 44 44 44 44 44 44
tone 192-223: 44 44 44 44 44 44 44 44 44 44 44 44 44 33 33 33
tone 224-255: 33 33 33 33 33 33 33 33 33 33 22 22 22 22 22 00