|
dopo aver inserito la chiave o il disco esterno lancia il comando "dmesg", ti dovrebbe dare informazioni dettagliate sulla periferica tra cui le partizioni trovate.
Io quando attacco il disco esterno ottengo questo:
------------------------------------------------------------------------------------------------
hub.c: new USB device 00:07.2-1, assigned address 3
usb.c: USB device 3 (vend/prod 0x5ab/0x60) is not claimed by any active driver.
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: IBM-DARA Model: -206000 Rev: AR2O
Type: Direct-Access ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 3
USB Mass Storage support registered.
reiserfs: checking transaction log (device 03:45) ...
Using r5 hash to sort names
ReiserFS version 3.6.25
reiserfs: checking transaction log (device 03:42) ...
Using r5 hash to sort names
ReiserFS version 3.6.25
Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 11733120 512-byte hdwr sectors (6007 MB)
sda: sda1 sda2 < sda5 >
----------------------------------------------------------------------------------------
e, nel mio caso, la sda5 č la partizione che poi devo montare.
|