PDA

View Full Version : nuovo bios18 abit IC7/IC7-G


ibanez
05-11-2003, 22:38
Risolverā il problema dei divisori delle ram??????

ibanez
05-11-2003, 22:39
Sembra di si, anche il riconoscimento dei sata al boot

1. Fixed the problem that the hard disk on IDE-1 may not be detected by
when "OnChip SATA" is set to RAID.
2. Fixed the problem that CAS latency can not be set manually when the
CPU/DRAM is set to PSB800/5:4 or PSB800/3:2.
3. Remove some string in "PnP/PCI Configuration".
4. Fixed the problem that system will reboot instead of shutdown when the
"Wake Up by Alarm" is enabled.
5. Fixed the problem that there will be some wording error when set "Time
Alarm".
6. Fixed the problem that the system will shutdown if the fan speed is too
low and the "Shutdown When CPU FAN Fail" is enabled.
7. Enhance USB card reader compatibility.
8. Add Pentium 4 Extreme Edition support.
9. Fixed HDD size detected as 136GB when 200/250/300 GB SATA drives are
connected to SATA1 or SATA2 (ICH5 SATA channels)
10. Show the correct subsystem device ID of the USB 2.0 and IEEE 1394
controller. (IC7 only)
11. Fixed the problem that certain CD/DVD-ROM could not be correctly detected
when there is a HDD drive attached on the same IDE cable.
12. BIOS compile date: 10/30/2003

AndreaFx
06-11-2003, 06:54
Ottimo stasera lo provo subito :D:D

Grazie dell'info ;)

Ciaoooo