Problema con overclock

[over@z]

salve ho un e7200 con p5q lisca e 2*1gb ddr2 800mhz cl.6 valueram kingston

il problema: a 380fsb si inchioda e devo riavviare

l'obiettivo: raggiungere i 4ghz stabili

ecco i settaggi:

ecco qll che ho settato da bios:
fsb frequency:380
pcie frequency: 100
fsb strap: auto
dram frequency: 379
dram timings: auto
dram static read control: auto
dram read training: auto
mem. oc charger: auto
ai clock twister: auto
ai transaction booster: auto
cpu voltage:1,3v
cpu gtl reference: auto
cpu pll voltage: auto
fsb termination voltage: auto
dram voltage: 1,9v (kingston dichiara 1,8v)
nb voltage: auto
sb voltage: auto
pcie sata voltage: auto
load-line calibration: auto
cpu spread sprectum: auto
pcie spread spectrum: auto
cpu clock skew: auto
nb clock skew: auto
cpu margin enhancement: auto

ecco l'ultima foto:

http://www.pctunerup.com/up/results/_200810/th_20081030180148_superpi.JPG (http://www.pctunerup.com/up/image.php?src=_200810/20081030180148_superpi.JPG)

che devo fare??

[over@z]

up

[over@z]

up

[opendoor]

Hai provato a partire con fsb a 400 (strap 400) e ram a 400 6-6-6-18 ?
prova a d alzare un pò il vcore se non ci riesci, magari il problema è solo quello, ma occhio alle temperature...a proposito sei ad aria o a liquido ?
hai un buon ali ?

[Suhadi_Sadono]

Prova così. Aggiorna prima il bios alla versione 1406

AI Overclock tuner: Manual
CPU Ratio Setting: 9.5
FSB Frequency: 400
PCI-E Frequency: 101
FSB Strap to North Bridge: Auto
DRAM Frequency: 800
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual

1st Information:
CAS# Latency: 6
DRAM RAS# to CAS# Delay: 6
DRAM RAS# Precharge: 6
DRAM RAS# Activate to Precharge: 18
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: AUTO
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

DRAM Static Read Control: auto
DRAM Read Training: Auto
MEM. OC Charger: Auto
AI Clock Twister: Stronger
AI Transaction Booster: Auto


CPU Voltage: 1.3250v
CPU GTL Voltage Reference (0/2): Auto
CPU GTL Voltage Reference (1/3): Auto
CPU PLL Voltage: 1.54v
FSB Termination Voltage: 1.36v
NB Voltage: 1.26v
DRAM Voltage: 1.85v
NB GTL Reference: Auto
SBridge Voltage: Auto
PCIE SATA Voltage: Auto

Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Enabled
CPU Clock Skew: Auto
NB Clock Skew: Auto
CPU Margin Enhancement: Optimized

P.S
Le tue ram non sono da overclock per cui vanno impostati i valori dichiarati da Kingston