Raulo
20-03-2008, 20:19
ciao ragazzi sto installando un pc, la scheda madre è una sapphire pure element (690g), il problema è che ho acquistato un alimentatore ch enon ha l'attacco a 8 pin.
Io pensavo fosse opzionale, nel senso che servisse per dare piu corrente se richiesta, invece proprio non parte.
So per certo che il motivo è quello perchè poi per provare ho collegato un corsair 520 e va perfettamente, ma se non collego l'attacco a 8 pin non parte manco con lui.
Anche leggendo il manuale della mobo, che vabbè è in inglese, mi sembra di cpaire che non sia necessario, perchè dice "without this connector migh cause system unstable because the power supply can not provide sufficient current for system".
Voglio dire, se non partiva proprio potevano scriverlo, no?
Mi confermate che è necessario o dite ci sarà qualcosa da fare?
Ho notato un jumper con scritto "power on jumper", ma sul manualetto striminzito ne parla solo dicendo:
"Power connector (24pin block):ATXPWR1 This is a new defined 24pins connector that usually comes with atx case. The atx power supply allows using soft power on momentary switch that connect from the front panel switch to 2-pins Power On jumper pole on the motherboard. When the power switch on the back of the atx power supply turned on, the full power will not come into the system board untuil the front panel swithcing is momentarily pressed. Press the switch again will turn off the power to the system board"
Non ho capito nulla di quello che sta scritto :mc:
:help: :help:
edit: scusate ho visto che ci sono opportuni adattatori 4/8 pin quindi potrò usare il cavo 4pin per i 12v?
boh pensavo non fosse indispensabile: mi sbagliavo a sto punto :)
Io pensavo fosse opzionale, nel senso che servisse per dare piu corrente se richiesta, invece proprio non parte.
So per certo che il motivo è quello perchè poi per provare ho collegato un corsair 520 e va perfettamente, ma se non collego l'attacco a 8 pin non parte manco con lui.
Anche leggendo il manuale della mobo, che vabbè è in inglese, mi sembra di cpaire che non sia necessario, perchè dice "without this connector migh cause system unstable because the power supply can not provide sufficient current for system".
Voglio dire, se non partiva proprio potevano scriverlo, no?
Mi confermate che è necessario o dite ci sarà qualcosa da fare?
Ho notato un jumper con scritto "power on jumper", ma sul manualetto striminzito ne parla solo dicendo:
"Power connector (24pin block):ATXPWR1 This is a new defined 24pins connector that usually comes with atx case. The atx power supply allows using soft power on momentary switch that connect from the front panel switch to 2-pins Power On jumper pole on the motherboard. When the power switch on the back of the atx power supply turned on, the full power will not come into the system board untuil the front panel swithcing is momentarily pressed. Press the switch again will turn off the power to the system board"
Non ho capito nulla di quello che sta scritto :mc:
:help: :help:
edit: scusate ho visto che ci sono opportuni adattatori 4/8 pin quindi potrò usare il cavo 4pin per i 12v?
boh pensavo non fosse indispensabile: mi sbagliavo a sto punto :)