kristian0
25-04-2007, 12:12
Vi prego aiutatemi a togliere questo dubbio tarloso dalla testa:
è vero che la piastra intel D850GB ha bisogno di riempire tutti gli slot rimm per accendersi??
Leggendo qui, sul sito intel
http://www.intel.com/support/motherboards/desktop/d850gb/sb/cs-013246.htm
"When installing memory, note the following:
* The four RIMM sockets are grouped into two banks:
o Bank 0 (labeled on the board as RIMM1 and RIMM2)
o Bank 1 (labeled on the board as RIMM3 and RIMM4)
* Bank 0 must be populated first ensuring that the RDRAM installed in RIMM1 and RIMM2 is identical in speed, size, and density. For example, the minimum system configuration would use two 64 MB RIMM modules of PC600 or PC800 RDRAM.
* If the desired memory configuration has been achieved by populating Bank 0, then Bank 1 should be filled with two Continuity RIMMs."
Cioè la piastra vede le rimm come 2 banchi formati a loro volta da 2 slot fisici che vanno riempiti con moduli rimm gemelli!!
Ma leggo bene che alla fine c'è scritto che se riempo il banco 0 devo riempire il banco 1?? Cioè devo riempire 4 slot??
Perchè prima c'è scritto che la configurazione minima sono 2 moduli rimm gemelli da 64 mb sul banco 0... E' una contraddizione!!
Qualcuno mi aiuti!!
Altre info sulla piastra intel D850gb
http://www.intel.com/support/motherboards/desktop/d850gb/
è vero che la piastra intel D850GB ha bisogno di riempire tutti gli slot rimm per accendersi??
Leggendo qui, sul sito intel
http://www.intel.com/support/motherboards/desktop/d850gb/sb/cs-013246.htm
"When installing memory, note the following:
* The four RIMM sockets are grouped into two banks:
o Bank 0 (labeled on the board as RIMM1 and RIMM2)
o Bank 1 (labeled on the board as RIMM3 and RIMM4)
* Bank 0 must be populated first ensuring that the RDRAM installed in RIMM1 and RIMM2 is identical in speed, size, and density. For example, the minimum system configuration would use two 64 MB RIMM modules of PC600 or PC800 RDRAM.
* If the desired memory configuration has been achieved by populating Bank 0, then Bank 1 should be filled with two Continuity RIMMs."
Cioè la piastra vede le rimm come 2 banchi formati a loro volta da 2 slot fisici che vanno riempiti con moduli rimm gemelli!!
Ma leggo bene che alla fine c'è scritto che se riempo il banco 0 devo riempire il banco 1?? Cioè devo riempire 4 slot??
Perchè prima c'è scritto che la configurazione minima sono 2 moduli rimm gemelli da 64 mb sul banco 0... E' una contraddizione!!
Qualcuno mi aiuti!!
Altre info sulla piastra intel D850gb
http://www.intel.com/support/motherboards/desktop/d850gb/