DjSolidSnake86
12-02-2007, 22:46
guardate questo test fatto con speed fan.. in pratica mi segnala dei settori danneggiati, c'è qualche programma x tentate di ripristinarli? (qualche programma intuitivo e di semplice utilizzo se possibile grazie ^^)
Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of info, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are a very good approach to what a professional would say about your hard disk status.
Your hard disk is a ST3160023AS with firmware 3.18.
The average temperature for this hard disk is 38C (MIN=26C MAX=50C) and yours is 36C.
Your hard disk's S.M.A.R.T. attributes are now being analyzed and a full report about the reliability, health and status of your hard disk is generated:
Your hard disk is not below any attribute threshold. This is good.
Your hard disk was never below any attribute threshold. This is good.
Your hard disk is now being compared to real data used to define normal values for your specific hard disk model. This way, the analysis can automatically use proper operating ranges. The images give you an idea of how each attribute is within such range. Current and raw values are shown for easier reference for experienced users. There are 1286 hard disk models in the current archive.
Attribute Current Raw Overall
Raw Read Error Rate 60 66312106 Good
Spin Up Time 98 0 Very good
Start/Stop Count 100 38 Very good
Reallocated Sector Count 100 0 Very good
Seek Error Rate 86 438416072 Very good
Power On Hours Count 86 12865 Normal
Spin Retry Count 100 0 Very good
Power Cycle Count 99 1426 Normal
Hardware ECC Recovered 60 66312106 Good
Current Pending Sector 100 7 Very good
Offline Uncorrectable Sector Count 100 7 Very good
Ultra DMA CRC Error Rate 200 0 Very good
Write Error Rate 100 0 Very good
TA Increase Count 100 0 Very good
All of the attributes of your hard disk have normal values. This is good.
NOTE : your hard disk has 7 pending sectors. Those are sectors that couldn't be properly read and that the hard disk logic is waiting for a write operation to try to remap to a spare sector (if available). According to the Reallocated Sector Count attribute, your hard disk seems to have available spare sectors. A simple disk surface scan won't be enough to force the remap operation. You need a read/write surface scan to remap the sector. The best option should be a tool that knows about what should be read from that sector so that it has some option to apply the best fix to the missing data.
NOTE : your hard disk has 7 offline uncorrectable sectors. Those are sectors that an offline scanning found as unreadable. Offline scanning is a process that can be automatically started by the hard disk logic when a long enough idle period is detected or that can be forced by some tool. Those unreadable sectors are identified and the hard disk logic is waiting for a write command that will overwrite them to try to remap them to spare sectors (if available). According to the Reallocated Sector Count attribute, your hard disk seems to have available spare sectors. A simple disk surface scan won't be enough to force the remap operation. You need a read/write surface scan to remap the sector. The best option should be a tool that knows about what should be read from that sector so that it has some option to apply the best fix to the missing data.
The overall fitness for this drive is 90%.
The overall performance for this drive is 96%.
The link to get back and see a new report about this hard disk in the future is this. Consider that new hard disks and new checks are added over time.
Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of info, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are a very good approach to what a professional would say about your hard disk status.
Your hard disk is a ST3160023AS with firmware 3.18.
The average temperature for this hard disk is 38C (MIN=26C MAX=50C) and yours is 36C.
Your hard disk's S.M.A.R.T. attributes are now being analyzed and a full report about the reliability, health and status of your hard disk is generated:
Your hard disk is not below any attribute threshold. This is good.
Your hard disk was never below any attribute threshold. This is good.
Your hard disk is now being compared to real data used to define normal values for your specific hard disk model. This way, the analysis can automatically use proper operating ranges. The images give you an idea of how each attribute is within such range. Current and raw values are shown for easier reference for experienced users. There are 1286 hard disk models in the current archive.
Attribute Current Raw Overall
Raw Read Error Rate 60 66312106 Good
Spin Up Time 98 0 Very good
Start/Stop Count 100 38 Very good
Reallocated Sector Count 100 0 Very good
Seek Error Rate 86 438416072 Very good
Power On Hours Count 86 12865 Normal
Spin Retry Count 100 0 Very good
Power Cycle Count 99 1426 Normal
Hardware ECC Recovered 60 66312106 Good
Current Pending Sector 100 7 Very good
Offline Uncorrectable Sector Count 100 7 Very good
Ultra DMA CRC Error Rate 200 0 Very good
Write Error Rate 100 0 Very good
TA Increase Count 100 0 Very good
All of the attributes of your hard disk have normal values. This is good.
NOTE : your hard disk has 7 pending sectors. Those are sectors that couldn't be properly read and that the hard disk logic is waiting for a write operation to try to remap to a spare sector (if available). According to the Reallocated Sector Count attribute, your hard disk seems to have available spare sectors. A simple disk surface scan won't be enough to force the remap operation. You need a read/write surface scan to remap the sector. The best option should be a tool that knows about what should be read from that sector so that it has some option to apply the best fix to the missing data.
NOTE : your hard disk has 7 offline uncorrectable sectors. Those are sectors that an offline scanning found as unreadable. Offline scanning is a process that can be automatically started by the hard disk logic when a long enough idle period is detected or that can be forced by some tool. Those unreadable sectors are identified and the hard disk logic is waiting for a write command that will overwrite them to try to remap them to spare sectors (if available). According to the Reallocated Sector Count attribute, your hard disk seems to have available spare sectors. A simple disk surface scan won't be enough to force the remap operation. You need a read/write surface scan to remap the sector. The best option should be a tool that knows about what should be read from that sector so that it has some option to apply the best fix to the missing data.
The overall fitness for this drive is 90%.
The overall performance for this drive is 96%.
The link to get back and see a new report about this hard disk in the future is this. Consider that new hard disks and new checks are added over time.