[Stigmata]

1. Cut the ends of a plastic bottle or jar to form a roughly 3.5" wide tube.
2. Poke 4 holes in the tube and "hard mount" your drive.
3. Wrap bubble-wrap around the tube, secured with tape or a rubber band. Ideally this bubble-wrap extends a little bit beyond the ends of the plastic tube.
4. Stick the wrapped tube at the bottom front of the case, so it gets air from the front intake.

Voila! An easy zero cost solution, which is very secure and safe. Vibrations are completely isolated, with the combined effects of the slightly flexible plastic tube and the bubblewrap.
The only potential downside is that the sides of the hard drive get no airflow. You could address this by using a ~5.25" wide bottle/jar and mounting with 3.5"->5.25" hard drive adapters.

Questo è molto carino, lo si può benissimo allungare per creare un tunnel dedicato agli HD da posizionere sul fondo del case [N.d.Stig.]


http://www.silentpcreview.com/forums...ic.php?t=22815